Timberline Controls can provide motion control solutions that best fit your application requirements.
  We have the expertise to apply electrical, hydraulic and pneumatic equipment to provide the highest
  quality system at the lowest cost.

  The experienced staff at Timberline Controls can compliment the right control design that will
  result in a system that will exceed your expectations. Our system design approach includes the
  customer in all aspects of the project. From the conceptual design stage to the final commissioning
  of the system, our goal is to have a satisfied customer who feels good about the products and
  services provided by Timberline Controls, Inc.

  Services provided include:

    Control Engineering - Component selection, sizing, modeling and simulation.

    Electrical Engineering - Motor controls, data acquisition, programmable controllers.

    AC Drives - Vector drives (sensor less open loop and flux vector closed loop), Volts/Hz.

    Hydraulic Engineering - Power unit design (open and closed loop), pressure and flow control
       systems, servo and proportional valves, set-works cylinders and drive motors.

    Pneumatic Engineering - Air preparation, pneumatic positioning systems, air logic,
       vacuum control, pressure and flow control.

    Programming - PLC/RTU, C/C++, Visual Basic/C++, HMI/MMI, SCADA systems.

    UL508A Panel Assembly - Motor control center, console/HMI, Nema 4X and hazardous locations.